Hydro-Mix HT-EX High Temperature Sensor
Installation and Mounting
Comprising a single, intelligent unit that contains all on-board functionality including signal processing and averaging, the Hydro-Mix HT-EX precisely measures the moisture content of material passing over the ceramic faceplate.

Electrical Installation
The integrated 4m cable of this sensor has to be terminated outside of the protected area or within a suitable housing that complies with the relevant protection zone. All connections within the protection zone must be made with the power supply isolated.
Installation into Mixers or Conveyors
The Hydro-Mix HT-EX can be mounted in many different locations where there is a continuous flow of material across the ceramic faceplate. These can include drying, ducting, conveying and mixing systems.
Single/Twin Shaft Mixers

The Hydro-Mix HT-EX should ideally be positioned on the end wall of the mixer, 30° from vertical and on the upstroke of the blade.
Screw Conveyors

The Hydro-Mix HT-EX is positioned on the upstroke of the blade at 30° from vertical.