Hydro-View

Touch screen system to view data and manage Hydronix Sensors

Installation Points:

  • Unit can be installed in an operator panel or in the Hydronix steel enclosure.

Unique Key Features:

  • 10.1" touch screen system to view data and manage Hydronix Sensors.
  • Connects a network of up to 16 Hydronix sensors with multiple systems simultaneously.
  • Easy to install in new or existing systems
  • Live display to view measurements of up to 6 sensors.
  • Calibrate and configure Hydronix sensors remotely.
  • 256 calibrations per sensor.
  • Ethernet Port with web browser interface / Web API.
  • 1175 HV05 Wall Mount Enclosure
  • 1187 PROFIBUS Module
  • 1189 PROFINET Module
  • 1188 Ethernet/IP Module
  • 1190 Digital Input Expansion Card
Digital Technology
Digital technology provides precise, linear moisture measurement.
Advanced Digital Signal Processing
The sensor response may be adjusted remotely using the Hydro-Com software to minimise the effects of noise of the measured signal. Advanced Digital Signal Processing provides a clear signal with a rapid response.
Measurement Modes
Choice of measurement modes for optimising sensor performance in a variety of applications and material types (except Hydro-Probe).
Fully Temperature Compensated Measurement
The sensor internally adjusts for mechanical changes due to temperature fluctuations
Easy to Interface
Two analogue outputs and digital RS485 communications and configurable digital inputs / output make the sensor simple to integrate into a control system. Includes Modbus.
Fast Measurement
Measuring at 25 times per second, the sensor continuously detects changes in the moisture of the materials throughout processing.
Temperature Measurement
Temperature output is available to provide a readout of material temperature.
Accuracy of Measurement
All measurements can be calibrated to an accuracy of 0.2% for aggregates (0.1% in the mixer) and 0.5% for other materials.
Sensor Configuration
Sensors can be remotely configured using Hydro-Com diagnostic software or Hydro-View/Hydro-Hub. All readings and sensor parameters are available including the type of output and filtering characteristics.
Calibration
The sensor may be internally calibrated using Hydro-Com software, or the linear output may be calibrated within the control system or remotely by using the Hydronix Hydro-View/Hydro-Hub interfaces.
Simple Power Requirements
The sensor may be powered from a 15-30V dc supply. Multiple sensors may be driven from a single power source.
Modbus to control system
Input / Output connections
Recommended field cabling:
  • Six pairs twisted (12 cores total) screened (shielded) cable with 22 AWG, 0.35mm2 conductors
  • Screen (shield): Braid with 65% minimum coverage plus aluminium/polyester foil
  • Recommended cable types: Belden 8306, Alpha 6373
  • Maximum cable run: 100m, separate to any heavy equipment power cables

Enquire about Hydro-View

Support

Check out our technical resources for self-help.
For further support with your Hydronix installation, please contact our friendly support team.

Resources

© 2024 Hydronix Ltd. Registered in England No. 01609365